Response Slots can be configured with the RESPOND command If enabled, response slots allow a radio to temporarily transmit on the given slot if it is issued a command. A new Response Slot concept has been added to all TDMA enabled radios.The SMLISTEN command can be used to configure the listen slots. This mode functions similarly to Sleep Mode 2 (TX Only) except that it also listens on the specified slots. A new Sleep Mode 5 “Slot-Listen Mode” has been added.Overall power consumption has been reduced.System maintainers will find the new format very useful TDMA Debug outputs have been enhanced.The DSR line now indicates if the proximity alarm has been tripped if it is enabled.All M7 family products now contain a bootloader allowing future upgrades without any disassembly.The ATLAS PT contains all the features of the PL, which in turn contains all the features of the M7-GX. Thus, while it is possible to map IP Codes to NEMA ratings that satisfy or exceed the IP Code criteria, it is not possible to map NEMA ratings to IP codes, as the IP Code does not mandate the additional requirements.Ĭategories: General, Installation Information | No Comments »Īlong with D55 is the initial release of Raveon’s latest upgrade to the ATLAS PL, the ATLAS PT. However, it also dictates other product features not addressed by IP codes, such as corrosion resistance, gasket aging, and construction practices. The United States National Electrical Manufacturers Association (NEMA) also publishes protection ratings for enclosures similar to the IP rating system published by the International Electrotechnical Commission (IEC). Protects against long periods of immersion under pressure.

Protected against the effect of immersion between 15 cm and 1 m. for use on ship decks – limited ingress permitted. Protected against temporary flooding of water, e.g. Protected against low pressure jets of water from all directions – limited ingress. Protected against dust limited ingress (no harmful deposit). Protection against water sprayed from all directions – limited ingress permitted. Protected against solid objects over 1 mm (tools, wires, and small wires). Protected against direct sprays of water up to 60 o from the vertical. Protected against solid objects over 2.5 mm (tools and wires). Protection against direct sprays of water up to 15 o from the vertical. Protected against solid objects over 12 mm, e.g. Protection against vertically falling drops of water e.g. Protected against solid objects over 50 mm, e.g. A summary is in the following table: IP Rate IEC standard 60529 defines the IP rating code system. The IP codes in their specific position indicate protection against dust (5) and protection from low water pressure (6). So, what does it mean when something is ‘weatherproof’? The term weatherproof is often used for IP65 rated cases like the one used for most of Raveon’s data radios.

Teraterm 4.71